Skip to content
English
  • There are no suggestions because the search field is empty.

Troubleshooting: Entagged LED is not lighting up

Table of contents

Overview

If your Entagged device is not lighting up, please try the following steps:

Troubleshooting steps

  1. 1Make sure your camera is on: The Entagged is powered by the camera, so if it is off, the LED will also remain off.
  2. 2Check the cable orientation: The HDMI cable powers the Entagged M. If it is plugged in incorrectly, the Entagged won’t receive power and the LED will not light up.
    The USB cable on Entagged N1 and N2 can also cause issues if reversed—it may power the device but prevent the LED from turning on.
    To connect properly: with the Entagged logo facing you and its port facing upward, plug the “Foolography” end of the HDMI cable into the Entagged.
    • M and N1: Cable should point to the right.
    • N2: Cable should point to the left.
  3. 3N1/N2 models — Check your Entagged orientation: Ensure the logo is correctly oriented with the line positioned at the bottom.
  4. 4N1 model — Check your depth: Gently wiggle your Entagged into the port to ensure it fits snugly.

Use QR tagging as a backup

Are you mid-shoot and need to quickly use an alternative tagging method? Learn how to switch to QR tagging as a backup method.